u
*
Electrical Shock Hazard
Unplug the refrigerator before removing a light bulb.
Failure to do so can result in death or electrical shock.
Your refrigerator has several light bulbs. This sec- tion shows you where they are located and tells you how to change them if they burn out. Before you change any light bulb in your refrigerator, be sure to turn the Refrigerator Control to OFF and unplug the refrigerator. After you have replaced the bulb, plug the refrigerator in and reset the Refrigerator Control to the desired setting.
NOTE: Not all commercial appliance bulbs will fit your refrigerator. Be sure to replace the bulb with one of the same size and shape.
To change the refrigerator light:
1.Reach behind the Control Panel and remove the bulb.
2.Replace the bulb with a
To change the crisper light
1.Pull the top of the light shield forward until it snaps free and lower until the light bulb is visible.
2.Replace the bulb with a
3.Pull the top of the light shield up over the bulb and snap it onto the side wall supports.
NOTE: To remove light shield for cleaning, remove the crisper and the crisper cover. Then release the bottom of the shield from the lower side wall supports. Pull the light shield out from above the crisper cover and wash it with warm water and a liquid detergent. Dry the cover and replace it in the reverse order.
