Check if...
The freezer door is not closed completely.
The water tank has not filled.
The water
The water
There is a kink in the home water source line.
There is a water filter installed on the refrigerator. This filter may be clogged or incorrectly installed.
Then...
Push the door firmly shut. If it will not shut all the way, see “Thedoors will not close completely,” on page 35.
The water tank needs to be filled the first time it is used. Depress the water dispenser bar with a large container until you draw two or three quarts
(1.9 to 2.8 L) of water. Discard water. (Refer to page 19 for further instructions on filling the water tank.)
Check to be sure the water
Refer to pages 9 and 10. Call the Consumer Assis- tance Center at
If you find or suspect a kink in the water line, call the Consumer Assistance Center at
First, check the filter installation instructions to ensure that the filter was installed correctly and is not clogged. If installation or clogging is not a problem, call the Consumer Assistance Center at
WATERORICEISEAKINCFROMTHEDISPENSER
I Check if... | Then... |
The glass is not being held under the ice dispenser long enough, causing the ice to spill.
The glass is not being held under the water dispenser long enough, causing water to drip.
An ice cube is stuck in the chute and holding the trap door open.
Hold the container under the ice chute for two to three seconds after releasing the dispenser lever. A small amount of ice may dispense after the lever is released.
Hold the container under the water dispenser two to three seconds after releasing the dispenser lever. Water may continue to dispense during this time.
Remove the cube.
THEDISPENSERWATERISNOTCOOLENOUGH
Check if...
The refrigerator has been newly installed,
A large amount of water has been recently dispensed.
No water has been recently dispensed.
Then...
Allow 24 hours for the tank to cool comoletelv.
Allow 24 hours for the tank to cool completely.
The first glass of water may not be cool. Discard the first glass of water.
33
