Whirlpool ED20TWXDN02 manual Attachingtheicemakertoawater, hlNC CONT.1, Toolsrequired, 1MPORTANT

hlNC (CONT.1

4.Make sure that the doors are even. If the freezer door is lower than the fresh food door, turn the leveling screw on the freezer side clockwise. If the fresh food door is lower, turn the leveling screw on that side clockwise.

5.Replace the base grille.

-

6.If you are not hooking up an ice maker, connect the refrigerator to the electrical supply after leveling, and then see page 12.

---

ATTACHINGTHEICEMAKERTOAWATER

Readall directionscarefullybeforeyoube@.

Electrical Shock Hazard

Unplug the refrigerator before installing ice maker.

Failure to do so can result in death or electrical shock.

NOTE: Your appliance dealer has a kit available with a %-inch saddle type shut-off valve, a union, and copper tubing. Before purchasing, make sure a saddle type valve complies with your local plumb- ing codes. Do not use a piercing type or G-inch saddle valve which reduces water flow and clogs more easily.

Cold water supply

The ice maker water valve contains a flow washer which is used as a water pressure regulator. The ice maker needs to be connected to a cold water line with water pressure limitations of 20-120 psi. If a problem occurs, call your utility company.

IMPORTANT:

e Use copper tubing only and check for leaks.

@Install ice maker tubing in areas where temperatures are above freezing.

Toolsrequired:

0 Standard screwdriver

0 7/16-inch and M-inch open-end wrenches or two adjustable wrenches

8 X-inch nut driver

l N-inch drill bit

l Hand drill or electric drill (properly grounded)

1MPORTANT:

*It may take up to 24 hours for your ice maker to begin producing ice.

@If operating the refrigerator before installing the water connection, turn ice maker to the OFF position to prevent operation without water.

l All installations must be in accordance with local plumbing code requirements.

INSTALLATION IS NOT WARRANTED BY REFRIGERATOR OR ICE MAKER MANUFACTURER.