INSTALLINGYOURREFRIGERATOR
It is important to prepare your refrigerator for use. This section tells you how to clean it, connect it to a power source, install it, and level it.
UNPACKINGYOURREFRIGERATOR
Removingpackagingmaterials
Remove tape and any labels from your refrigerator before using (except the model and serial number label).
To remove any remaining tape or glue, rub the area briskly with your thumb. Do not use sharp instruments, rubbinq alcohol, flammable fluids, or abrasive cleaners. These products can damage the surface of your refrigerator. For more information, see “Important Safety Instructions” cn page 3.
NOTE: Do not remove any permanerit instruction labels inside your refrigerator, or the Tech Sheet that is tastened under the front.
cleaningbefore use
After you remove all of the packaging materials, clean your refrigerator before using it if needed. See the cleaning instructions on page 24 for more information.
EIHTRKA~REQUIREMENTS
Before you move your refrigerator int#I its final location, it is important to make sure you have the proper electrical connection.
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded electrical supply is required. It is recom- mended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. Refer to the Electrical Requirements and Grounding Instructions Sheet in your Literature Package for more details.
NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turi the Refrigerator Control to OFF and then unplug the refrigerator. When you are finished with any of these steps, plug the refrigerator in and reset the Refrigerator Control to the desired se:ting.
7
