Removing the oven door | Whirlpool RMC305PD, GMC275PD, GMC305PD

Removing the oven door

For normal use of your oven, you do not need to remove the door. However, you can remove the oven door by following the instructions in this section.

The oven door is heavy. Use both hands to remove and replace the door. Do not lift and carry the door by the handle. To remove and replace the door you may need help.

To remove:

1. Open door all the way.

NOTE: Two 5⁄32" Allen wrenches or two nails of similar diameter may be used if factory furnished door removal pins have been misplaced. Be careful not to damage porcelain finish.

Insert small end of pin here

2.Insert small end of a door removal pin into each door hinge.

3.Grasp under handle and gently close door as far as it will shut. Pull door out at bottom to remove.

4. Set door aside on protected surface.

CARING FOR YOUR OVEN

To replace:

1.Fit hinge arms into slots in frame. Push in at lower corner to ensure that hinge arms are fully engaged.

2.Open the door all the way.

3.Remove the door removal pins from each hole.

4.Close the door.

NOTE: If the door does not operate freely, you have not installed it properly. Repeat Steps 1 through 4.

23

Image 23

Whirlpool RMC305PD, GMC275PD warranty Removing the oven door, To remove Open door all the way, Insert small end of pin here

Contents

4452006A Use And Care Thank you for buying a Whirlpool appliance Your safety and the safety of others is very important Oven Safety Oven Safety Model RMC275PD/RMC305PD shown Parts and Features Bakeware choices Using Your OvenWhere to place pans Positioning racks and pans Will occur to the oven bottom finish Do not cover Using aluminum foilElectronic oven control Display/clock Set time Setting the clockAudible signals Starting a function Using the electronic Minute TimerTo cancel the Minute Timer Disabling the timer reminder tones Baking/roasting Canceling a functionWhen roasting or cooking casseroles, put food in oven Set temperature optional Hold for Factory setting Seconds Adjusting the oven temperature controlWhen baking, put food in oven after oven is preheated Set new offset temperature Place the rack where you need it Enter the adjustmentHow to determine the amount of adjustment needed To display temperatures in C instead of F Broiling guidelines To custom broil at a lower temperature Using the electronic Mealtimer control Disabling the Cook Time reminder tones Set the temperature optionalWhen baking/roasting is done Set the cook time or stop time Display counts down cook time When the start time is reachedSet the start time Set the cook time Oven vent Before you start Using the Self-Cleaning CycleBefore you start the Self-Cleaning cycle, make sure you After the Self-Cleaning cycle ends Setting the controlsTo start cleaning immediately Set the cleaning time optional Example for 230 start time After the Self-Cleaning cycle startsTo stop the Self-Cleaning cycle at any time Time In Hours How the cycle works Caring for Your Oven Cleaning chart Insert small end of pin here Removing the oven doorTo remove Open door all the way Oven lights To turn the lights on or off when the oven door is closed Cooking results TroubleshootingWhen self-cleaning your oven Oven does not work Display messages Our consultants provide assistance with If you need assistance or serviceIf you need replacement parts For further assistance Whirlpool