A
D
B
C
E
+
English
Button
sewing
foot
IMPORTANT: This button foot works for buttons with either two or four holes; however,
less than 5 mm. | button, which | |
Before sewing, make sure that the needle does not hit the | ||
A. | Measure the distance between two holes ®. |
|
B. | • Raise the presser foot lift and lower the feed dog. |
|
| • Select Stitch No.2 and set the stitch width to the same length as the |
the distance between the holes must be may cause the needle to break or bend.
distance between the holes © set stitch
C.
• •
length to “0’. |
|
Place a button on the fabric | |
Turn the handwheel | toward |
|
where the button should be sewn and lower you and check that the needle drops in both
the left
presser foot on
and right holes
top of the button. correctly without
D.
E.
. |
| |
hitting the button | first. | |
• When sewing a button with four holes, sew the front set of holes | ||
| ||
Then shift the button toward you and sew another set of holes. |
| |
• Set the speed control lever to slow and press the foot control. |
| |
• After sewing, gently pull the lower thread on the wrong side of the fabric | ||
both thread ends to secure the finish. |
| |
When button sewing is complete, raise the feed dog. |
|
and
pull
out
the
upper thread.
Tie