White Rodgers HC-TST501CMMS manual Select temperature display as, Select air filter maintenance

Advanced Installer Configuration Menu

Thermostat Setup

Furnace User Menus

Status I

Parameter	Indications		Comments
Main Limit	Closed, Open	Main Limit Control Status
MRLC Input	Closed, Open	Main Reset Limit Control Status
HALC Input	Closed, Open	Heat Assist Limit Control Status
IDM Output	Off, Lo, Hi	Inducer Output Status
Furn Lo Pr Sw	Closed, Open	Furnace Low Pressure Switch Status
Furn Hi Pr Sw	Closed, Open	Furnace High Pressure Switch Status
Gas VLV Prcnt %	XXX%, Off	Mod Gas Valve % Open
Gas VLV Relay	Lo, Hi, On, Off	Gas Valve Control Output Status
Flame	Off, Marginal, Good,	Status of Flame Sensor
	Unexpected
Blower CFM	CFM XXXX	Furnace Blower CFM
Status 2
Parameter	Indications		Comments
Mode	Mod Heat, Lo Heat, Hi Heat,		Indicates Operating Mode of System
	AC1, AC2, Fan Only, Off,
	HP1, HP2
Motor Mfgr	Regblt, Emerson		Blower Motor Manufacturer
Motor RPM	RPM		Blower Motor RPM
Maximum CFM	CFM XXXX		Maximum CFM Blower Provides
Blower CFM	CFM XXXX		Displays Current Operating CFM
Temp Rise	NA, XXXF		Difference between the Supply and
			Return Air Temperature
Return Temp	XXXF, FLT		Displays Return Air Temp (if installed)
Supply Temp	NA, (If disabled), XXXF, FLT		Displays Supply Air Temp (if installed
			and enabled in setup)
HUM Output	On, Off		Humidifier Output Relay Status
EAC Output	On, Off		Electronic Air Cleaner Output Relay
			Status

1

2

1

2

1

2

Select temperature display as

Fahrenheit or Celsius. Scrolling message will show “SELECT TEMPERATURE DISPLAY”. This option selects the temperature display as °F or °C.

Select beeper (audio prompt) Default is On for the beeper to indicate a touch key selection. It can be changed to OFF.

Select air filter maintenance

reminder. Scrolling message will show “AIR FILTER MAINTENANCE”. Default is OFF. It can be changed to a setting from 25 to 1975 hours in increments of 25 hours to select the amount of time for the reminder. Consult your contractor for the hours and type of filter. Setting of 225 hours is typically 3 months of run time.

When the system has run for the selected length of time, the scrolling message area will show “CHANGE FILTER” to indicate maintenance is

required.