White Rodgers HC-TST501CMMS manual Equipment User Menus, Auto Mode, Check System Status

Advanced Installer Configuration Menu

Equipment User Menus

The equipment found in the system will display in the scrolling message area.

Touchorto step through the list of equipment connected, including thermostat.

1

2

To view the Equipment Menus information for the equipment displayed in the scrolling message area, touch Installer Config to enter that equipment submenu listing. The scrolling message area will show “WORKING” to indicate that the thermostat is retrieving data. Then the first equipment submenu name appears in the scrolling message area.

Touch Menu to step out of the equipment submenu parameters back to the equipment submenu. Each touch of Menu will step up one menu level back to the Thermostat Options Configuration Menu. Touch the Run Schedule to step out of all menus and back to the Home Screen Display.

Using the Thermostat

Auto Mode

In Programmable mode or Non-programmable mode, you can touch the SYSTEM key to select AUTO to allow the thermostat to automatically change between Heat and Cool. When the SYSTEM key is touched to select Auto the thermostat will change to Heat or Cool, whichever ran last. If it switches to heat but you want cool, or it changes to cool but you want heat, touch bothorkeys simultaneously to change to the other mode.

Choose the FAN Setting (Auto or On). FAN Auto is the most

commonly selected setting and runs the fan automatically when the heating or cooling system is on.

FAN On selection runs the fan continuously for increased air circulation or to allow additional air cleaning. When FAN is selected On, it will run at the speed selected in the Thermostat Options Configuration Menu.

Note: FAN On Prog will display to indicate that the fan has been programmed to be on for the complete period. To change the Programmable Fan setting, see page 18 in the Homeowner User Guide.

Check System Status

If the Home Screen Display indicates “Call for Service” and “Check (Equipment Name)” in the scrolling message area, there is a fault in the system. When this fault is displayed, refer to the Advanced Installer Configuration Menu Fault status

If the thermostat indicates “Call for Service” with “CHECK SYSTEM”, the indoor unit is not detected or has failed to communicate.