Windsor 10086130, 10086150 manual Filling Solution Tank, Normal Scrubbing

MACHINE OPERATION

FILLING SOLUTION TANK

FOR SAFETY: Before leaving or servicing machine; stop on level surface, turn off machine and remove key.

1.Turn the machine power off.

2.Remove the front cover and the solution fill lid.

3.Fill the solution tank with clean water. (See the Technical Specifications chart for exact capacity). The water must not be hotter than 140° F (60°C) to prevent damage to the tank.

4.Replace the solution fill lid and front cover.

DELUXE

1.Turn the machine power off.

2.Remove the front cover and the solution fill lid.

3.Fill the “A” tank with either encapsulating interim carpet cleaning or prespray chemical.

4.Fill the “B” tank with extraction chemical.

5.Turn machine power on.

6.Prime chemical system by holding the prime switch to the “A” position for 30 seconds then holding the prime switch to the “B” position for 30 seconds. If using only one chemical tank, prime only that system.

Flammable materials can cause an

explosion or fire. Do not use flammable materials in the tanks.

NORMAL SCRUBBING

Plan the scrubbing pattern in advance.

For efficient operation, the runs should be the longest possible without turning, stopping, or raising or lowering scrub deck. The longest track is around the perimeter of the area to be cleaned and a collapsing rectangle pattern is most efficient.

In order to achieve the best possible results, the area which is to be cleaned, should be vacuumed before scrubbing. Large debris, strings and wire must be removed to prevent being caught in brushes.

If the machine is allowed to stand in neutral with the scrub deck down for more than 2 seconds, the solutions flow stops and brush motor stops. When forward travel is resumed, the solution flow and the scrub brush motor will continue. Overlap the brush path and avoid transporting over previously cleaned areas.

RECOMMENDED SCRUBBING PATH

3-12 86292490 VOYAGER DUO 08/20/07