Windsor 10086150 manual 4-12, Maintenance-Solutionstrainer & Pump - Basic, Solution Strainer, Jets

Models: 10086150 10086130

1 136
Download 136 pages 7.47 Kb
Page 35
Image 35
1.SOLUTION STRAINER

MAINTENANCE-SOLUTION STRAINER & PUMP - BASIC

1.SOLUTION STRAINER

The solution strainer is located on the front of the machine under the front cover. The strainer protects the pump, solenoid valve and jets from debris. If there is little or no solution flow to the ground, check the strainer for debris. Clean the solution strainer. To remove the strainer, turn the bottom part of the strainer counterclockwise until the bottom is separated. Clean out the debris from the wire mesh and the bowl and re- assemble. Make sure the O-ring gasket is in place when re-assembled.

2.PUMP

The pump is located on the front of the machine under the front cover. The pump delivers solution from the tank to the scrub deck.

To repair or replace pump:

1.Remove front cover.

2.Remove hoses connecting the pump.

3.Remove screws that secures pump to mounting plate.

3.SOLENOID VALVE

The solenoid valves are mounted on the front of the scrub deck, on left side.

The solenoid valves shuts off solution flow to jets whenever scrubbing stops or in reverse. To repair or replace solenoid valve, remove screws that secure it to deck.

4.JETS

The two sets of jets are located in front of the scrub deck.

The jets spray cleaning solution onto the carpet. The spray pattern should be checked regularly and if jets become clogged they should be cleaned or replaced immediately.

To clean jets:

1.Remove jet from jet body by rotating it counterclockwise.

2.Blow debris back through orifice if possible. Do not use pointed object to unplug jet. This will damage jet and cause improper spray pattern and solution flow through jets.

3.If jet cannot be cleaned by blowing debris back through its orifice, submerge jet in small container of acetic acid and let soak for up to six hours.

4.After soaking jet, use a soft brush to remove debris and rinse thoroughly.

5.Install jet in jet body by rotating it clockwise firmly into place.

6.For lower flow in extraction “B” other jets are available. ( see Suggested Spare Parts).

PUMP REPLACEMENT PARTS

PUMP HEAD REPLACEMENT

VALVE ASM

DIAPHRAGM

(86136450 PRV 65151)

(86137240 PRV 84145)

ASM.

 

86292490 VOYAGER DUO 08/20/07

4-12

Page 35
Image 35
Windsor 10086150 4-12, Maintenance-Solutionstrainer & Pump - Basic, Solution Strainer, To repair or replace pump, Jets