Windsor 10086150, 10086130 manual 4-20, Maintenance-Vacuum, To Clean Vacuum Shoes

VACUUM SHOES

The dual offset vacuum shoes are designed to extract soiled solution from the carpet. The plastic vacuum shoe glides minimize wear to flooring.

MAINTENANCE

The vacuum shoes should be removed and cleaned daily to ensure maximum recovery.

VACUUM SHOE REMOVAL

1.Unscrew retainer knob from right side vacuum shoe.

2.Pull vacuum shoe forward until it is free from pivot pin.

3.Remove vacuum hose from top of vacuum shoe

4.Repeat to remove left side vacuum shoe.

5.Inspect or repair as necessary and reinstall.

MAINTENANCE-VACUUM

TO CLEAN VACUUM SHOES

1.With the vacuum shoes in the raised position, turn key switch “off”.

2.Remove vacuum shoes.

3.Flush vacuum shoes from top with water. If necessary, clean blockage from narrow opening with a scraper or similar device.

4.Vacuum shoe glides may be removed for cleaning (or replaced) by removing the three pins that secure them to metal vacuum shoes.

RECOVERY TANK FLOAT SHUT-OFF

When water is no longer being vacuumed from the floor and the vacuum fan is operating, the ball float has engaged. The vacuum motors will not vacuum water with recovery tank full. The recovery tank must be drained.

1.The float shut-off screen can be cleaned in or out of the machine.

2.To clean the float shut-off while it is inside the machine wipe material off screen then rinse. Check that the ball is also clean and moves freely.

3.To remove the float shut-off, grasp the elbow with one hand tilt and pull the float screen assembly to pull it off the elbow.

4.To install, place one hand on the elbow, and then tilt and push the float screen assembly over the elbow.

86292490 VOYAGER DUO 11/15/08 4-20