Woods Equipment BW240HDQ manual Owner Service, Gearbox Lubrication, Driveline Lubrication

Models: BW240HD BW240HDQ

1 76
Download 76 pages 32.6 Kb
Page 20
Image 20
LUBRICATION

1.

Driveline U-joint

10 Hours

2.

Telescoping shaft

10 Hours

3.

Carrier bearing block

40 Hours

4.

CV body assembly

10 hours

 

(10 pumps minimum)

 

5.

Driveline shield

10 Hours

6.

Splined yoke

10 Hours

7.

Gearbox (above lower

Daily

 

line on dipstick)

 

8.

Tongue pivot

40 Hours

9.

Wheel yoke pivot

40 Hours

10.

Gearbox (bottom of

Daily

 

side hole)

 

11.

Tailwheel spindle

20 Hours

12.

Turnbuckle

40 Hours

Figure 4. Jackstand Placement and Lubrication Points

LUBRICATION

Do not let excess grease collect on or around parts, particularly when operating in sandy areas.

See Figure 4 for lubrication points and frequency or lubrication based on normal operating conditions. Severe or unusual conditions may require more fre- quent lubrication.

Use a lithium grease of #2 consistency with a MOLY (molybdenum disulfide) additive for all locations unless otherwise noted. Be sure to clean fittings thoroughly before attaching grease gun. One good pump of most guns is sufficient when the lubrication schedule is fol- lowed.

Gearbox Lubrication

For gearbox, use a high quality gear oil with a viscosity index of 80W or 90W and an API service rating of GL– 4 or –5 in gearboxes. Splitter Gearbox; Fill gearbox

until oil runs out the side plug on gearbox. Wing Gear- box; Fill gearbox until oil is just above lower line on dip- stick. Check gearbox daily for evidence of leakage, and contact your dealer if leakage occurs. Use sealant on vent plug threads during installation. Check vent plug periodically and clean if it does not relieve pressure.

Driveline Lubrication

1.Lubricate the driveline slip joint every eight operating hours. Failure to maintain proper lubrication could result in damage to U-joints, gearbox, and driveline.

2.Lower cutter to ground, disconnect driveline from tractor PTO shaft, and slide halves apart but do not disconnect from each other.

3.Apply a bead of grease completely around male half where it meets female half. Slide drive halves over each other several times to distribute grease.

20 Owner Service

(Rev. 11/9/2009)

MAN0763 (10/10/2008)

Page 20
Image 20
Woods Equipment BW240HDQ manual Owner Service, Gearbox Lubrication, Driveline Lubrication