Install Spring Wheel Arms
1.Slide right spring wheel arm assembly (14) over center wheel yoke tube and secure into position using four cap screw (28) and flanged lock nut (37). Repeat step to install left spring wheel arm assembly. Keep spacing as wide as possible for greater stability.
2.Attach wheels to hubs using five lug nuts. Install the chamfered side of the lug nut toward the inside for steel rim for pneumatic tires and rims. Tighten to 75
NOTE: Install the flat side of the nut toward the inside for solid tires and aircraft tires (shown).
NOTE: Pneumatic, notat, and airplane tires are available for this cutter. See page 61 for parts list.
14. Spring wheel arm assembly
28. 3/4 NC x 6 HHCS GR5
37. 3/4 NC Flange lock nut
Figure 24. Right Spring Wheel Arm Installation
Install Tongue
1.Attach tongue (22) to center section using two tongue pivot pins (31). Secure pivot pins to mast plates using carriage bolts (67) and lock nuts (53).
NOTE: Attach hose holder (25) to right mast plate with hardware shown.
2.Attach both attitude rods (4) to lower holes on tongue and secure with clevis pin (32), washer (33), and cotter pin (63).
3.Attach parking jack (20) to the side of the tongue.
4.Attitude rod
20.Parking jack
22.Tongue
25. Hydraulic hose holder
31.Tongue pivot pin
32.Clevis pin, 1" x 2.26"
33.Washer, flat 1"
53. 1/2 NC Flange lock nut
63. Cotter pin, 1/4" x
67. 1/2 NC x 2 Carriage bolt
Figure 25. Tongue Installation
MAN0763 (10/10/2008) | Assembly 35 |
|
|
