Manuals / Woodstock / Power Tools / Planer

Woodstock W1724, W1723 instruction manual Gib bolt tightening sequence

Models: W1723 W1724

1 48

Download 48 pages 44.97 Kb

Page 21

NOTICE

Uneven tightening or over-tightening the gib bolts may warp the cutterhead, causing it to become unbalanced, which will lead to premature knife and bearing wear from vibration.

To tighten the knives after adjustment, do these steps:

1.UNPLUG THE PLANER!

2.Alternating back-and-forth, lightly snug the gib bolts by following the tightening sequence shown in Figure 20, but DO NOT tighten the bolts completely.

3.Rotate the cutterhead to the next knife and repeat Step 2, and then repeat again with each knife. When all knife gib bolts have been snugged, and you come back to the knife you started with, check the knife height with the jig to make sure that it is still set correctly.

•If the height is incorrect, readjust

as necessary and re-snug the gib bolts.

•If the height is correct, snug each bolt down a little more in the same alternating method as in Step 2, but DO NOT tighten the bolts completely. Repeat this tightening sequence again with each knife.

4.When you return to the original knife, tighten all gibs completely in the same fashion, repeating on all knives.

5.Recheck the knife height on all knives with the jig to make sure that the height is still correct.

•If the height is incorrect, repeat Steps 2 through 5 until correct.

5

3

1

2

4

Figure 20. Gib bolt tightening sequence.

ADJUSTMENTS

19

Image 21

Woodstock W1724, W1723 instruction manual Gib bolt tightening sequence

Contents

Models Page Contents Woodstock Service and Support IntroductionAbout Your New Planer Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstSafety Additional Safety Instructions for Planers 220V Operation ElectricalExtension Cords GroundingAssembly Box ContentsOverview Shop Preparation Cleaning PlanerStand W1723 HandwheelTo mount the handwheel and crank, do these steps To mount the extension rollers, do these steps Extension RollersKnife Setting Jig W1723 To assemble the knife setting jig, do these stepsSpiral Knife Alignment Tool W1724 Planer Overview AdjustmentsTo check the cutterhead-to-table alignment, do these steps Cutterhead AlignmentUnderside of planer table Adjustments Inspecting Knives W1723 Knife Replacement procedureTypical Shop FOX cutterhead Knife Replacement W1723Gib bolt tightening sequence Spiral knife system Knife Replacement W1724Twisting knife and aligning gib Feed Rollers Chip Breaker Chip breaker height adjustment To adjust the chip deflector, do these steps Chip DeflectorAnti-Kickback Pawls Roller Spring Tension To adjust the roller spring tension, do these stepsTable Bed Rollers To adjust the table bed roller height, do these stepsOperations Always Wear Safety Goggles When Operating This machineTest Run Feed RateOperational Tips Only plane a clean workpieceSolutions Troubleshooting Planing ResultsMaintenance General CleaningGear box drain and fill plugs LubricationBelt Tension To adjust the belts, do these stepsSymptom Possible Cause Corrective Action Troubleshooting Machine OperationPlaner Accessories Maintenance Maintenance Description Maintenance Long T Allen Wrench 4MM Maintenance Angle 191⁄2 Long W1723 and W1724 15 Planer Wiring Diagram Warranty Card BOX BELLINGHAM, WA