Feed Speed, Feed control knob positions | Woodstock W1754S specs

W1754 20" Planer With Mobile Base

Feed Speed

The infeed and outfeed rollers power the stock through the planer while keeping boards flat and providing a con- sistent rate of movement.

The power feed features high/low feed rates. The speed should only be changed when the machine is running. Use the different feed rates as stated below:

16 FPM	Dimensioning Pass
20 FPM	Finishing Pass

Figure 12 illustrates the three different positions of the feed control knob.

NOTICE

Only change the speeds when the planer is running, but DO NOT attempt to change speeds during any cutting operations or damage to the gearbox will result.

��

��

Figure 12. Feed control knob positions.

OPERATIONS

-19-

Image 33

Woodstock W1754S owner manual Feed Speed, Feed control knob positions

Contents

Model W1754S Planer With Spiral Cutterhead B68=C HE886IDCH `gg`e`d\ej`fej Xikfe Headstock Breakdown Description Headstock Parts List Gearbox Breakdown Cabinet Breakdown Gearbox Parts List Table Breakdown Columns Breakdown Labels & Cosmetics Page Planer with Mobile Base Page Contents Woodstock Technical Support Introduction Introduction Controls and Features Standard Safety Instructions Safety Always Lock Mobile Bases Before Operating Machinery Additional Safety Instructions for Planers Electrical Specifications Electrical220V Operation Items Needed for Setup SetupUnpacking Inventory Machine Placement Lifting PlanerHardware and Tools Not Shown These items are coated and must be cleaned Cleaning Machine Extension wing fasteners Leveling controls Extension Wings To install the handwheel, do these steps To install the caster and foot pedal, do these stepsHandwheel, Dust Hood Caster Connecting to Power Gearbox Oil LevelTo check the gearbox oil level, do these steps To perform a test run, do these steps Test Run Tighten V-Belts Recommended Adjustments General OperationsBasic Operation Basic steps of operating the planer are as follows Operation Tips Feed control knob positions Feed Speed Adjustment Height Range 002-0.020 To adjust the bed rollers, do these stepsBed Rollers Planer Accessories Accessories Operations Maintenance CleaningMaintenance Schedule To adjust/replace the V-belts, do these steps BeltsPulley Alignment on Lubrication Service Inspecting KnivesTo inspect the knives, do these steps To set the knives, do these steps Setting/Replacing Knives Chain Tension To adjust the chain tension, do these steps Maximum Allowable Tolerances Table Parallelism Table micro-adjustment screws To adjust the table parallelism, do these steps Distance Below Knife Edge at *BDC Rollers, Breaker Pressure Bar Heights Location Service Spring Tension To adjust roller spring tension, do these steps Scale Calibration Loosen the chip deflector mounting bolts see FigureTo calibrate the scale, do these steps Anti-kickback fingers Anti-Kickback Fingers Example of checking belt Alignment Pulley Alignment Motor junction box W1754 Electrical Components W1754 20 Planer With Mobile Base Problem Possible Cause Corrective Action Troubleshooting Cutting Headstock Assembly Parts Breakdown PART# Description Headstock Assembly Parts List Cutterheadpulley Gearbox Parts Breakdown XPSB06M CAPSCREWM6-1X25 Base Breakdown Base Parts List Table Breakdown & List Columns Breakdown Columns Parts List Labels & Cosmetic Parts Warranty Page Comments Warranty Registration BOX BELLINGHAM, WA