Model W1829 (Mfg. Since 9/11)

Test Run

SETUP

Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation.

The test run consists of verifying the following: 1) The motor powers up and runs correctly, and 2) the safety disabling mechanism on the switch works correctly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 28.

If you still cannot remedy a problem, contact our Tech Support at (360) 734-3482 for assistance.

To test run the machine, do these steps:

1.Make sure you understand the safety instructions at the beginning of the manual, and verify that the machine is set up properly.

2.Ensure all tools and objects used during setup are cleared away from the machine.

3.Verify that the machine is operating correctly by turning it ON.

When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

4.Turn the machine OFF.

5.Remove the switch disabling key (see Figure 20).

6.Try to start the machine with the paddle switch.

If the machine does not start, the switch disabling feature is working as designed.

If the machine does start, immediately stop the machine. The switch disabling feature is not working correctly. Call Tech Support for help.

Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses to reduce the risk of injury.

Loose hair and clothing could get caught in machinery and cause serious personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.

Figure 20. Removing switch key from

paddle switch.

-18-

Page 20
Image 20
Woodstock W1829 manual Test Run, To test run the machine, do these steps