Setting 45 Outward Stop, Outward stop bolt detail | Woodstock W1829

Model W1829 (Mfg. Since 9/11)

Setting 45° Outward Stop

1.DISCONNECT JOINTER FROM POWER!

2.Loosen the fence tilting handle, remove the limit block and set it aside.

3.Tilt the fence backward (away from the table) until it stops.

Note: The fence will stop when the outward stop bolt hits the fence bracket.

4. Use a square to check the angle of the fence, as shown in Figure 47.

— If the fence is tilting away from the table at 45º, the outward stop is set correctly. Put the limit block back, bring the fence to 90°, and tighten the tilting handle.

—If the fence is not tilting away from the table at 45º, perform Steps 5–6to set the outward stop correctly.

Figure 47. Checking the outward 45º stop.

5.With the outward stop bolt resting against the fence bracket, use an 8mm wrench to adjust the length of the stop until the fence is at 45º, then tighten the jam nut (see Figure 48).

6.Put the limit block back, bring the fence to 90º and tighten the fence tilting handle.

Outward

Stop Bolt

Jam Nut

Figure 48. Outward stop bolt detail.

SERVICE

-35-

Image 37

Woodstock W1829 manual Setting 45 Outward Stop, Outward stop bolt detail

Contents

OWNERS MANUAL Page Contents Woodstock Technical Support IntroductionAbout Your Machine Model W1829 Model W1829 Mfg. Since 9/11 W1829 identification-rear view Controls & Features Standard Machinery Safety Instructions Safety Safety Additional Safety for Jointers Circuit Requirements ElectricalFull-Load Current Rating Circuit Requirements for Extension Cords Grounding RequirementsFor 110V Connection Unpacking SetupInventory Jointer Inventory Figures Qty Machine dimensions Machine Placement Cleaning Machine Example of a direct mount Bench Mounting To assemble the jointer, do these steps Assembly Fence positioned over Jointer tables To install the dust port and collection bag, do these steps Recommended AdjustmentsDust Collection Recommended CFM at Dust Port Connecting Power Power Connection To test run the machine, do these steps Test Run General OperationsBasic Controls Stock Inspection Requirements Correct setting for grain Alignment Surface plane on the jointer Squaring Stock Jointer Surface Planing To edge joint on the jointer, do these steps Edge Jointing To bevel cut on the jointer, do these steps Bevel Cutting D3319-6 Replacement Jointer Knives Set AccessoriesD3640-Shop Fox Tool Table Plus W1218A-Rotacator W1041-3 x 2 1⁄2 Adapters W1044-4 x 2 1⁄2 Adapters D2675-Safety Glasses D2676-Adjustable Safety Glasses Cleaning MaintenanceTable & Base Belts Troubleshooting ServiceMotor & Electrical Operation Adjusting Knife height Checking/Adjusting Knife HeightChecking Knife Height Tools Needed Qty Knives Laceration injuries may occur. Use Cutterhead clamp screw Location Replacing Knives Setting 90 Fence Angle Stop Setting Fence Angle Stops Checking the inward 45º stop Inward Stop Bolt Setting 45 Inward Stop Outward stop bolt detail Setting 45 Outward Stop To realign or replace the cutterhead belt, do these steps Belt Replacement To replace motor brushes, do these steps Motor Brush Replacement Wiring Diagram Color KEY Electrical Safety Instructions 110 VAC Wiring Diagram Main Parts Description Parts List Labels Parts Woodstock international inc. p.o. box Bellingham, Wa Warranty High Quality Machines and Tools