Model W1829 (Mfg. Since 9/11)

Squaring Stock

Squaring stock involves four steps performed in the order below:

1.Surface Plane on the Jointer: The concave face of the workpiece is surface planed flat with the jointer (see Figure 26).

2.Surface Plane on a Thickness Planer: The opposite face of the workpiece is surface planed flat with a thickness planer (see Figure 27).

3.Edge Joint on the Jointer: The concave edge of the workpiece is jointed flat with the jointer (see

Figure 28).

4.Rip Cut on a Table Saw: The jointed edge of the workpiece is placed against a table saw fence and the opposite edge cut off (see Figure 29).

Figure 26. Surface plane on the jointer.

This Side Previously

Surface Planed

Figure 27. Surface plane on a thickness

planer.

Figure 28. Edge joint on the jointer.

 

 

This Side

 

 

Previously Edge

 

45

Jointed

15

30

 

Figure 29. Rip cut on a table saw.

OPERATIONS

-21-

Page 23
Image 23
Woodstock W1829 manual Squaring Stock, Surface plane on the jointer