-14-
Model W1829 (Mfg. Since 9/11)
SETUP
Assembly
To assemble the jointer, do these steps:
1. DISCONNECT JOINTER FROM POWER!
2. Use two of the included M8-1.25 x 20 cap screws and
lock washers 8mm to attach the fence support to the
jointer bed, as shown in Figure 9.
3. Insert the locking plate assembly into the fence
support, positioning it so the two pins are against
the bottom edge of the fence support, as shown in
Figure 10.
4. Secure the locking plate in position with the fence
sliding handle, as shown in Figure 11.
5. Use the remaining four M8-1.25 x 20 cap screws and
8mm lock washers to attach the fence to the fence
bracket assembly, as shown in Figure 12.
Figure 9. Attaching the fence support.
Figure 10. Inserting the locking plate.
Figure 11. Installing fence sliding handle.
Figure 12. Attaching the fence bracket
assembly to the fence.
Fence
Support
Locking
Plate Pins
Locking Plate
Assembly
Locking Plate
Assembly
Fence Sliding
Handle
Bracket
Assembly
Cap
Screws
Fence
Cap Screws