Xantrex Technology HF 1800 Status LED During Inverter Mode, Checking Battery Status, 12.8, 0.85

Operating in Inverter Mode

Status LED During Inverter Mode

The following summarizes the behavior of the Status LED during Inverter mode.

Table 4-1Status LED during Inverter Mode

Status LED	Display Screen		Condition
Solid	12.8		Select button is pressed to display Input Battery Voltage.
YELLOW	(where 12.8 is an		The Input Battery Voltage LED lights up.
	example of battery		Value in display screen is shown as Volts.
	voltage)
	11		Select button is pressed to display Input Current.
	(where 11 is an		The Input Current LED lights up.
	example of current)		Value in display screen is shown as Amps.
	0.85		Select button is pressed to display Output Power.
	(where 0.85 is an		The Output Power LED lights up.
	example of output		Value in display screen is shown as Kilowatts.
	power in Kilowatts)
	E05 through	e07	Warning condition detected while AC output power is still
			available.
			See Table 5-1, “Error Codes Displayed on the Display Panel
			Screen” on page 5–5.
Solid RED	E01 through	e04	Fault condition detected and AC output power is not
			available. The unit will sound an alarm and will shutdown
			completely within 30 seconds.
			See Table 5-1, “Error Codes Displayed on the Display Panel
			Screen” on page 5–5.
Off	Off		Inverter is OFF.
Off (or Yellow)	00.0		No communication between the Freedom HF and the Display
			Panel because the battery voltage was too low to start the
			Inverter.

Checking Battery Status

During inverter mode, you can check the battery status by pressing the Select button until the Input Voltage LED (or Input Current LED) illuminates. The battery voltage (or battery current) appears in the three- digit LED display screen when the Input Voltage LED (or Input Current LED) illuminates.

The normal operating battery voltage range is between 11 and 15 volts.

975-0390-01-01 4–5