Software History

Software Enhancement Rev. E 1.5

The Link 10 now includes the following additional functions:

F02 - ENHANCED SLEEP MODES

DEFAULT: ON Range: ON, OFF, AUTOMATIC

When the Sleep Mode is ON, the Link 10's numeric display turns off after 10 minutes in order to reduce power consumption. Pressing either SET or SEL buttons returns the numeric display to operation.

When the Sleep Mode is OFF, the numeric display stays on at all times. In the AUTOMATIC sleep mode (displayed as AUt), the numerics are on whenever charging or discharging exceeds 1 amp. When the rate of charge or discharge remains less than 1 amp for 10 minutes, the numeric display is turned off to conserve power. When asleep, pressing either SET or SEL reactivates the numeric display. The numeric display automatically wakes up when the rate of charge or discharge exceeds 1 amp. The Automatic Sleep Mode is ideal for electric vehicles.

TIME REMAINING DISPLAY

DEFAULT: 001 Range: 000, 001, 002, 003, P

When P is selected, an averaged Time Remaining number is not displayed. Instead, the Link 10 reports rate compensated percent of (declared) Battery Capacity Remaining. A full battery is displayed as 100P and the display decrements during discharge to 00P.

If you have selected a discharge floor other than 100%, the percent of battery capacity remaining is referenced to the selected discharge floor and uses the instantaneous (not averaged) rate of discharge.

This function is useful on electric vehicles where time remaining numbers are of little value. NOTE: This display shows the rate compensated capacity percentage which drives the bar graph.

56