Xantrex Technology RS232-XHR manual RS-232 Interface Subplate Located on Power Supply Rear Panel

Installation and Configuration

Initial Inspection

J7 User Signal Connector

Error LED (ERR)

Indicates that a programming error has occurred. Clear with error query command.

Address LED (ADR)

Indicates that the unit is being addressed by the master controller.

	S1 Switch	RS-232 Connector
	1-1, 2, 3 Baud Rate Selection
	1-4 Flow ON/OFF Selection	Switch Position Reference
	1-5 XON Switch
		markings (0) (1)
	Hardware/Software Flow Control Selection
	Note: On some models, the subplate is rotated 180 degrees.
Figure 2.2 RS-232 Interface Subplate
	(Located on Power Supply Rear Panel)

CAUTION

Use proper static control techniques to avoid damage to static-sensitive components on the printed circuit board

Release 3.1 21