Xerox 4050 IPS, 4090 IPS manual Trace Mode Options window

SETTING THE SYSTEM CONFIGURATION

The Trace window contains the following options and field:

•

•

•

Online — Enables the interface after you execute the trace.

Offline — Disables the interface so that you can execute the trace.

Trace Mode Options pull-down menu — Specifies how you want to perform the trace. You use the pull-down menu to specify the trace options you want to use. The selections are as follows:

—Normal Operation — Specifies no trace options are in effect.

—IPDS and Channel — Specifies that the trace will capture the channel command words (exchanged between the host and the printer and the IPDS data stream) into the trace file.

Note: This option displays only if “Channel” was selected from the Interface window. (Refer to the “Setting up the Printer Controller” chapter.)

—IPDS & TCP/IP — Specifies that the trace will capture the TCP\IP commands (exchanged among the host and the printer and the IPDS data stream) into the trace file.

Note: This option displays only if “TCP/IP” was selected from the Interface window. (Refer to the “Setting up the Printer Controller” chapter.)

—IPDS Only—Specifies that the trace will capture only the IPDS data stream into the trace file.

—Execute Trace — Specifies that the job will print as though it was received across the channel or the TCP/ IP interface.

4.From the Trace Mode Options pull-down menu, select IPDS & Channel, IPDS only, or IPDS & TCP/IP. Your selection is displayed in the lower right corner of the Trace Mode Options window, and the Trace Mode Options window displays.

Figure 4-13.Trace Mode Options window

XEROX DOCUPRINT 4050/4090 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM 4-19