Xerox 4050 IPS, 4090 IPS manual Example of an input configuration

SETTING THE SYSTEM CONFIGURATION

Example of an input configuration

Here is an example of a hypothetical input configuration you might create:

You have an application in which only IPDS trays 1 and 2 are called out, with most of the job calling for IPDS tray 1. The media you will be using are 20-pound white USLetter and 60-pound blue USLetter. You have a high-capacity feeder and would like to use all four available trays.

To accomplish this, you could create a configuration like this:

•In the IPDS Trays row, specify the 20-pound white stock in the IPDS Tray 1 cell and the 60-pound blue in the IPDS Tray 2 cell.

•

•

In the Printer Trays row, specify the 20-pound white paper in the cells for Printer Trays 1, 3, and 4.

Specify the 60-pound blue paper in the Printer Tray 2 cell only, because a relatively small amount of that stock will be required.

The following figure shows the configuration described above.

Figure 4-16.Example of an input configuration, displayed on the IPS main window

By invoking this configuration, you ensure your job will print as follows (be sure the physical printer trays actually contain the stock you specified):

•The IPS will feed from printer tray 1 for all parts of the job in which IPDS tray 1 is specified in the data stream. These pages will be printed on the 20-pound white paper.

XEROX DOCUPRINT 4050/4090 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM 4-27