DSC AND SCS DATA STREAM COMMANDS
Set Line Density (SLD)
2BC6nnld
Defines the vertical space required for one print line (Lines Per
Inch or LPI) overriding those set at the control panel.
2B Control sequence prefix of a Set Line Density
command
C6 Command class for a Set Line Density command
nn Number of bytes in the command string
including the byte count
Valid values are 01 and 02.
If nn equals 01, ld defaults to the value set at the
printer, except for the 3287 emulation, which
defaults to 6 LPI.
If nn equals 02, the ld parameter is used.
ld Line density or the distance moved for a single
line of vertical spacing.
Valid values for this parameter for each emulation
and the correlation between LPI and the ld
values are:
00 = 6 LPI 3262, 3268, 3287, 3812, 4245,
6262
09 = 8 LPI 3262, 3268, 3287, 3812, 4245,
6262
0C = 6 LPI 3262, 3268, 3287, 3812, 4245,
6262
12 = 4 LPI 3262, 3268, 3287, 3812, 6262
18 = 3 LPI 3262, 3268, 3287, 3812, 6262
Remember An invalid value for nn or ld causes all emulations to use a
default of 6 LPI and an invalid SCS parameter check to occur.
The exceptions to this are the 3262, 4245, and 6262 emulations,
which use the previously defined LPI value.
2-16 XEROX MRP FAMILY COAX COMMAND REFERENCE