Printing with tabs
Installing the tabs guide
Instructions for installation of the tabs guides are included with the
Feed Module Tab Guide kit. They are also available at
www.xerox.com (Customer Instructions: Feed Module Tab Guides
-Part # 701P42423) or on the Xerox Nuvera Customer Documentation CD.
Tab Optimization Mode
Tab Optimization Mode is available on the Xerox Nuvera 288 Perfecting System only. This mode maximizes productivity when printing mixed media jobs that include precut tab stock or full cut tab stock with a width greater than 8.5 x 11 inches (215.9 millimeters).
The number of images on the photoreceptor during a single revolution is referred to as a pitch mode. There are different pitch modes for different paper sizes. There is a deadcycle (no image on the photoreceptor) during a pitch mode change, which causes reduced productivity. In a tab job, the body pages and tab pages have different pitch modes, which causes deadcycling each time the press switches from one page size to the other. When Tab Optimization Mode is enabled, all pages are run with a single pitch mode to prevent deadcycling.
The throughput rate when Tab Optimization Mode is enabled is 240 impressions per minute, regardless of whether the job contains tab stock.
Precut tabs can be printed
To enable Tab Optimization Mode:
1.On the DocuSP Controller, select [Printer: Tab Optimization Mode]. A dialog window appears.
2.Select the [On] checkbox.
3.Close the window. The Tab Optimization Mode is enabled.
To disable Tab Optimization Mode:
1.On the DocuSP Controller, select [Printer: Tab Optimization Mode]. A dialog window appears.
2.Select the [Off] checkbox.
3.Close the window. The Tab Optimization Mode is enabled
Xerox Nuvera Paper Guide |