Xerox DP 1015 manual LED Indicator, To turn off the projector power

Connecting the Projector

To turn off the projector power

1.Press the Power button on the projector or remote control to turn off the projector lamp.

An on-screen message appears asking if you’re sure you want to turn off the lamp.

2.Press the Power button again to confirm.

If you don’t press the button within ten seconds, the message disappears and the lamp remains lit. This convenient design is

in case you accidently press the Power button in the middle of a show and do not want to turn off the projector.

If you do press the Power button a second time, the

LED indicator flashes rapidly. Then the projector automatically shuts itself down.

3.Do not turn on the projector again for at least two minutes. When the LED indicator is again flashing slowly it is safe to turn the lamp back on.

4.After two minutes, disconnect the power cord.

NOTE: Do not disconnect the power cord until the projector’s cooling fan stops (about two minutes). This protects the lamp from overheating and possible damage

LED Indicator

LED Indicator

•Slow flash—Normal operation; the power cord is plugged in.

•Steady light, not flashing—Normal operation; the lamp power is on and the projector is operating normally.

•Rapid flashing during lamp shutdown—Normal operation; the fan runs for about 30 seconds to cool down the lamp.

•Rapid flashing while the lamp is powered—Warning: either the lamp has overheated and the fan runs automatically, or the fan has malfunctioned. You cannot turn off the power to the lamp until it has cooled down.

Xerox DP1015 User’s Guide 13