Xerox I Class Advanced Entry Calibration continued, Step, Operator Action, Displayed Message

Advanced Entry Calibration (continued)

Step	Operator Action					Displayed Message	Comment
16	Press the		Key.				The selection
							will flash and
	Using the		or the		â		the display
		Key, set the					heading will
	‘Paper’ level to the value						change to
	determined in the previous						indicate the
					â
	step. Press the			Key			item for entry.
	to set the entry (indicated
	by the ‘*’) and advance the
	menu.					Or, for reflective media:

Repeat for the ‘Gap’ (or ‘Mark’) and ‘Empty’ levels.

â

â

17 After all entries have been		From ‘Ready’,
made, press the		press the FEED
Key to back out of the		Key to advance
menu and then press the		to the next label
	Key to save the	TOF.
settings and return to the
Ready Mode.

þNote: If the Advanced Entry Calibration fails, try the following procedure.

Re-enter Media Settings / Calibration / Advanced Entry / Sensor Gain and lower the selected Gain Setting number by one (to make the sensor less sensitive). Select the new Gain Setting, save the changes, exit the menu, and then test your media. Repeat the procedure until a usable media setting is obtained.

76 I-Class