
2 e 6 x 30 mm roundhead screw
Keyboard Stand Assembly
x Attach the back board.
Attach the back board, using the 6 x 30 mm roundhead screws e.
Make sure the
CAUTION
•Be careful not to drop the back board or touch the sharp metal fit- tings.
3 | y 4 x 45 mm flathead screws |
t Support rail |
|
|
r 5 x 16 mm roundhead
screws
c
Attach the support rail.
Spread a large soft cloth (such as a blanket) on the floor. Place the instrument on the cloth with the keyboard side facing down. Align the support rail t into the groove on the bottom of the instrument and attach the rail, using the 4 x 45mm flathead screws y.
v Put the keyboard on the stand.
Check the
CAUTION
•Be careful not to drop the keyboard or to get your fingers caught between the keyboard and the stand parts.
b Install the keyboard to the stand.
Fix the keyboard to the angle brackets, using the 5 x 16
mmroundhead screws r.
■Post-assembly checklist
Once you’ve assembled the stand, check the fol- lowing points:
•Are there any parts left over?
➔If so, read the assembly instructions again and correct any errors you might have made.
•Is the instrument clear of doors and other movable fixtures?
➔If not, move the instrument to an appropriate location.
•Does the instrument make a rattling noise when you play it or move it?
➔If so, properly tighten all screws.
•Also, if the keyboard makes a creaking noise or seems unsteady when you play it, refer carefully to the assembly instructions and diagrams and retighten all screws.