Yamaha DSP-AX863SE owner manual 35 En, If an error screen appears, If “WARNING” appears

■If an error screen appears

Press 9k / n / l / h to select “RETRY” or “EXIT” and then press 9ENTER.

The following display is an example when “E-9:USER CANCEL” appears in the OSD.

ERROR

.E-9:USER CANCEL Don't operate

any function

>RETRY EXIT

[[]/[[]:Select [ENTER]:Enter

Choices: RETRY, EXIT

•Select “RETRY” to retry the “AUTO SETUP” procedure.

•Select “EXIT” to exit from the “AUTO SETUP” procedure.

y

If “E-5:NOISY” appears, “PROCEED” also appears in the choices. When you select “PROCEED”, this unit continues the measurements and settings, but the settings may not be optimal.

Optimizing the speaker setting for your listening room (YPAO)

■If “WARNING” appears

When this unit detects potential problems during the “AUTO SETUP” procedure, “WARNING” appears in the top result display. Check the warning messages to correct your speaker settings.

Note

Warnings differ from errors in that warnings do not cancel the “AUTO SETUP” procedure.

1Make sure the pointer is pointing at “WARNING” and then press 9ENTER to

display the detailed information about the warning.

The number on the right of “WARNING” indicates the number of warning messages.

AUTO

.WARNING(3)

RESULT

SP : 3/4/0.1

DIST: 4.50/5.30m

LVL : -9.0/+6.5dB

>SET CANCEL

[]/[]:Up/Down [ENTER]:Detail

2Press 9l / h repeatedly to toggle between the warning displays.

WARNING

W-1:OUT

Reverse Channel

FL --

CENTER
PL	PR
SL	SR
SBL	SBR

[[]/[[]:Select

[ENTER]:Return

y

•For details about each warning message, see the “AUTO SETUP” section in “Troubleshooting” on page 103.

•When the corresponding warning message is not applicable to a speaker, “––” is displayed instead.

•If “SWFR: TOO LOUD” or “SWFR: TOO LOW” appears

in the “W-3: LEVEL ERROR” display, adjust the volume level of the subwoofer(s).

3Press 9ENTER to return to the top result

display.

PREPARATION

English

35 En