Yamaha DSP-AX863SE owner manual 77 En, Input rename INPUT RENAME, Decoder mode DECODER MODE, Notes

Input rename INPUT RENAME

Use this feature to change the name of the input source that appears in the OSD and in the front panel display.

J)DVR

INPUT RENAME

DVR . DVR

[p]/[[]: Position

[[]/[p]: Character

[ENTER]: Enter

[RETURN]: Return

1Press 9l / h to place the “_” (underscore) under the space or the character you want to edit.

2Press 9k / n to select the character you want to use and then press 9l / h to move to the next space.

Notes

•You can use up to 9 characters for each input.

•Press 9n to change the character in the following order, or press 9k to go in the reverse order:

A to Z, 0 to 9, a to z, symbols (#, *, –, +, etc.), space.

3Repeat steps 1 through 2 to rename each input source.

4Press 9ENTER to complete.

Volume trim VOL. TRIM

Use this feature to adjust the level of the signal input at each jack. This feature is useful if you want to balance the level of each input source to avoid sudden changes in volume when switching between input sources.

Control range: –6.0 dB to +6.0 dB

Control step: 0.5 dB

Initial setting: 0.0 dB

B)TUNER

INPUT RENAME

. VOL. TRIM;;;;+6.0dB

[[ p Up/Down

[p]/[[]: Adjust

y

This parameter also affects the signals output at the audio ZONE OUT jacks.

Customizing this unit (MANUAL SETUP)

Decoder mode DECODER MODE

Use this feature to switch the decoder activation mode. When you select “DTS” and digital audio signals are input, this unit always activates the DTS decoder and only plays back the DTS digital audio signals.

C)CD

I/O ASSIGNMENT INPUT RENAME

VOL. TRIM;;;;;0.0dB

. DECODER MODE;;;AUTO

[[	p	Up/Down
[p]/[[]: Select

Choice	Functions
AUTO	Automatically detects digital audio signal input
	types and selects the appropriate decoder.
DTS	Activates the DTS decoder and plays back only
	DTS digital audio signals when digital audio
	signals are input.

Note

“DECODER MODE” is only available when the digital audio input jacks (HDMI, OPTICAL, and/or COAXIAL) are assigned to the selected input source.

Charge on standby STANDBY CHARGE

Use this feature to select whether this unit charges the battery of the stationed iPod or not when this unit is in the standby mode.

Choice	Functions
AUTO	Charges the battery of the stationed iPod when
	this unit is turned on and in the standby mode.
OFF	Charges the battery of the stationed iPod only
	when this unit is turned on.

OPERATION ADVANCED

English

77 En