Yamaha DSP-AX863SE Playback, Basic procedure, 41 En, Rotate the EPROGRAM selector or press, unit

Playback

Caution

Extreme caution should be exercised when you play back CDs encoded in DTS. If you play back a CD encoded in DTS on a DTS-incompatible CD player, you will only hear some unwanted noise that may damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output level of your CD player before you play back a CD encoded in DTS.

y

To play DTS-encoded CDs when using a digital audio connection, set “DECODER MODE” in “INPUT MENU” to “DTS” before the playback (see page 77).

Before performing the following operations, set the operation mode selector on the remote control to FAMP.

3Start playback on the selected source component or select a broadcast station.

•Refer to the operating instructions for the source component.

•See page 52 for details about iPod operations.

•See page 54 for details about Bluetooth operations.

4Rotate BVOLUME (or press GVOLUME +/–) to adjust the volume to the desired output level.

y

•See page 51 to adjust the level of each speaker.

•This does not affect the AUDIO OUT (REC) level.

•You can set the initial volume level and maximum volume level (see page 72).

	5 Rotate the EPROGRAM selector (or press
Basic procedure
	one of the sound field program selector
	buttons (O) repeatedly) to select the desired
	sound field program.
1 Turn on the video monitor connected to this
	The name of the selected sound field program appears
unit.
	in the front panel display. See page 47 for details
y	about sound field programs.
See page 45 to display the input source information on the
video monitor.

2Rotate the IINPUT selector (or press one of the input selector buttons (5)) to select the desired input source.

The name of the currently selected input source appears in the front panel display for a few seconds.

Available input sources

MULTI CH VCR DVR V-AUX DTV/CBL DVD MD/CD-R CD TUNER PHONO

Currently selected input source

y

The corresponding input selector button on the remote control for the currently selected input source lights up for approximately 5 seconds after you press any buttons on the remote control, showing which source component is currently being operated.

Currently selected sound field program

Note

Sound field programs cannot be selected when the component connected to the MULTI CH INPUT jacks is selected as the input source (see page 42).

y

•Choose a sound field program based on your listening preference, not merely on the name of the program.

•When you select an input source, this unit automatically selects the last sound field program used with the corresponding input source.

•To display information about the currently selected sound field program in the OSD, see page 56 for details.

English

41 En