■Using a USB device
You can play back audio files, and picture files saved on your USB devices.
Supported USB devices
The DVD controller supports USB mass storage class devices (e.g., flash memories, card readers, portable audio players) using FAT16 or FAT32 format.
Notes
–Some devices may not work properly even if they meet the requirements.
–If “USB ERROR” or “NO USB” appears in the front panel display, see the following methods.
–Set the system to the standby mode, and then turn it on again.
–Disconnect the device when the DVD controller is in the standby mode, then connect it again and turn on the DVD controller.
–Set the input source to USB, then remove and insert the USB device.
–Select the input source other than USB, then Set it back to USB again.
–Connect the AC adapter if the adapter is supplied with the device.
–If the electrical power consumption of the USB device is high, the USB device may not be used correctly.
–Do not connect devices other than USB mass storage class devices: USB chargers, USB hubs, PCs, etc.
PLAYING OTHER DISCS
Playing data files
Yamaha and suppliers accepts no liability for the loss of data saved on the USB devices connected to the DVD controller. As a precaution, it is recommended that the files are tested after they have been saved on.
1Press DVD/USB repeatedly until “USB” appears in the front panel display.
2Connect your USB device to the USB terminal of the
DVD controller. | 4 |
| |
|
|
INPUT |
| BASIC |
| USB | OPERATIONS |
USB device
3Start playback in either of the following ways.
When playing back all files in a USB device Press hto start playback.
When playing back the selected files
Press MENU to open Disc Navigator.
Press 
/ 
/ 
/ 
to select files, then press h. Refer to page 34 for how to select files.
4Press sto stop playback. Before you remove the USB device, select an input source other than USB.
Note
When the input source is USB, you cannot open the
DVD setup menu.
English