Yamaha DVX-700 68 En, Tuner (FM), XM Satellite Radio

TROUBLESHOOTING

Problem	Cause	Remedy	See
			page
The picture is not displayed on the TV	The TV cables may be connected	Make sure all cables are connected	17
screen.	improperly.	properly.
	If the COMPONENT VIDEO	Disconnect the HDMI component, or	18
	OUTPUT and HDMI connections are	connect a TV that supports progressive
	used simultaneously, the	video to the COMPONENT VIDEO
	COMPONENT VIDEO OUTPUT	OUTPUT jacks.
	jacks may output progressive video
	signal regardless of the Component Out
	setting.
The picture is not displayed on the TV	The Video Output settings may be	Check the Video Output settings and	38
screen correctly.	incorrect.	correct as necessary.
	The Component Out setting is set to	Change the Component Out setting to	38
	Progressive, but the TV connected to	Interlace.
	the COMPONENT VIDEO OUTPUT
	may not support progressive scanning.
	The TV connected to the HDMI	Change the HDMI Resolution setting	38
	OUTPUT terminal may not support the	to a resolution supported by the HDMI
	selected resolution.	TV.
The message “HDMI ERROR” is	The wrong HDMI resolution may be	Check the HDMI Resolution setting	38
displayed or the picture is not	selected or an HDMI error may have	and correct as necessary.
displayed on the HDMI TV screen.	occurred.
		Reset the HDMI settings.	65

Tuner (FM)

Problem	Cause	Remedy	See
			page
FM stereo reception is noisy.	The characteristics of FM stereo	Check the antenna connections.	18
	broadcasts may cause this problem
		Try using a high-quality directional FM	--
	when the transmitter is too far away, or
		antenna.
	if the antenna quality is poor.
		Use the manual tuning method.	46
There is distortion, and clear reception	There is multi-path interference.	Adjust the antenna position to	--
cannot be obtained, even with a good		eliminate multi-path interference.
FM antenna.
The desired station cannot be tuned	The signal is too weak.	Use a high-quality directional FM	--
into with the automatic tuning method.		antenna.
		Use the manual tuning method.	46

XM Satellite Radio

If an operation takes longer than usual or an error occurs, one of the following messages may appear in the front panel display. In this case, read the causes and follow the corresponding remedies.

Status message	Cause	Remedy	See
			page
CHECK XM TUNER	The XM Mini-Tuner is not installed in	Confirm the XM Mini-Tuner is fully	50
	the XM Mini-Tuner Home Dock or the	seated in the dock and check that the
	XM Mini-Tuner Home Dock is not	XM Mini-Tuner Home Dock cable is
	connected to this unit.	connected to this unit.
CHECK ANTENNA	The XM antenna is not connected to	Check that the XM antenna is securely	50
	the XM Mini-Tuner Home Dock or the	connected to the XM Mini-Tuner
	XM antenna cable has become	Home Dock and check the antenna
	damaged.	cable for damage. Replace the XM
		antenna if the cable is damaged.

68 En