6.2 Mono Input Direct Out Jack:
Pre-Fader or Post-Fader (switch)
Pre-ON or Post-ON Switch (jumper)
A slide switch in each input module permits the
Direct Out point to be altered. As shipped, the console is
set so that the Direct Out point is derived after the EQ
and Fader (technically speaking, it comes after the VCA
which is controlled by the fader). If you wish the Direct
Out to be Pre-EQ and Fader (actually pre-VCA), move
the switch to the appropriate position, as illustrated.
As shipped, the direct out point comes ahead of the
Channel ON switch, and is thus not affected by the
Master Mute function. By changing internal jumpers,
you can alter the Direct Out point to be Post-ON switch,
also illustrated below in Figure 6-2.
Figure 6-2. Internal Switch Positions For Pre-Fader/EQ and Post-Fader/EQ
Direct Out Point; Internal Jumpers for Direct Out Pre/Post Channel ON Switch;
and Corresponding Block Diagram Location
Page 6-3