6.7 Stereo Input Channel Insert In/Out
for example, when one wishes to the send to the signal
Jacks: Pre-EQ or Post-EQ
processor... for example, to apply the boost prior to
compression. However, sometimes one wishes to equal-
Four jumpers in each stereo input module permit the
two pair of Insert In/Out points to be altered separately. ize equalize the return from a signal processor. In this
case, the In/Out points can be switched to come before
As shipped, the console is set so that the Insert In/Out
points come after the channel equalizer. This is useful, the channel equalizer. Move the jumpers to the appro-
priate position, as illustrated.
Figure 6-7. Internal Jumper Positions For Pre-EQ and Post-EQ Insert In/Out Points
on Stereo Input Module, and Corresponding Location on Block Diagram.
Page 6-8