6.4 Mono Input Cue/Solo Switch: Pre-Fader or Follow MT PRE Switch
so that the take-off point for the cue/solo signal tracks
the signal feed to the channel’s LED level meter. In
this way, the cue/solo feed will be post-fader (or post-
As shipped from the factory, the mono input channel
CUE/SOLO switch applies signal to the left and right
cue busses from a point which is derived just ahead of
the channel fader (actually, just ahead of the fader-
controlled VCA). However, an internal jumper in each
mono input module enables this function to be altered
VCA to be more exact) until the METER PRE switch is
set to Pre mode; then it will be pre-fader. The channel’s
CUE output has left and right components, but both
are derived from the same monaural signalThe switch
positions are illustrated below in Figure 6-4.
Figure 6-4. Internal Switch Positions For Cue/Solo being Pre-Fader
or tracking the METER PRE Switch on Monaural Input Module,
and Corresponding Block Diagram Location.
Page 6-5