Manuals / Brands / Home Audio / Stereo Receiver / Yamaha / Home Audio / Stereo Receiver

Yamaha RX-N600 Connecting the FM and AM antennas, 25 En, ■Connecting the AM loop antenna, PREPARATION, 1Set up the AM loop antenna

1 132

Download 132 pages, 2.37 Mb

CONNECTIONS

Connecting the FM and AM antennas

Both FM and AM indoor antennas are supplied with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals.

Notes

•Be sure to set the tuner frequency step (General model only) according to the frequency spacing in your area (see page 92).

•The AM loop antenna should be placed away from this unit.

•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.

•A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, install an outdoor antenna. Consult the nearest authorized YAMAHA dealer or service center about outdoor antennas.

AM loop antenna (supplied)

Indoor FM antenna (supplied)

2Press and hold the tab of the AM ANT terminal.

3Insert one of the AM loop antenna lead wires into the AM ANT terminal.

PREPARATION

TUNER

AM

ANT GND

FM ANT

75Ω

UNBAL.

Ground (GND terminal)

For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.

4Release the tab of the AM ANT terminal back into place.

Outdoor AM antenna

Use a 5 to 10 m (16 to 32 ft) of vinyl- covered wire extended from a window.

■Connecting the AM loop antenna

1Set up the AM loop antenna.

5Repeat steps 2 through 4 to connect the other lead wire to the GND terminal.

y

Once you have properly connected the AM loop antenna to this unit, orient the AM loop antenna for the best reception when you tune into AM stations.

25 En

Contents

Page IMPORTANT SAFETY INSTRUCTIONS FCC INFORMATION (for US customers) CAUTION: READ THIS BEFORE OPERATING YOUR UNIT CONTENTS 1 En FEATURES 2 En GETTING STARTED Supplied accessories Installing batteries in the remote control 3 En CONTROLS AND FUNCTIONS Front panel 4 En 5 En Remote control ■Controlling this unit 6 En 7 En ■Controlling the TUNER functions ■Using the remote control 8 En Front panel display 9 En 10 En Rear panel ■ VOLTAGE SELECTOR (General model only) 11 En CONNECTIONS Placing speakers 12 En Connecting speakers 13 En 14 En ■Connecting the speaker cable ■Connecting the banana plug (except Europe model) 15 En Information on jacks and cable plugs ■Audio jacks ■Video jacks 16 En Audio and video signal flow ■Audio signal flow for AUDIO OUT (REC) ■Video signal flow for MONITOR OUT 17 En Connecting a TV 18 En Connecting a DVD player, a DVD recorder, a VCR or an STB ■Connecting a DVD player 19 En ■Connecting a DVD recorder or a VCR ■Connecting an STB 20 En Connecting a CD player, an MD player or a tape deck 21 En Connecting a YAMAHA iPod universal dock 22 En Connecting the network 23 En Connecting a multi-formatplayer, an external decoder or a sound processor Connecting a game console, a video camera or a portable audio player 24 En Connecting the FM and AM antennas ■Connecting the AM loop antenna 25 En Connecting the power cable ■VOLTAGE SELECTOR (General model only) ■AC OUTLET(S) (SWITCHED) 26 En Setting the speaker impedance 27 En Turning on and off the power ■Turning on this unit ■Turning off this unit 28 En 29 En 30 En 31 En PLAYBACK 32 En 33 En USING AUDIO FEATURES Using SILENT CINEMA Selecting the night listening mode Muting the audio output 34 En Selecting the input mode Using the sleep timer 35 En Adjusting the speaker level 36 En Selecting the Compressed Music Enhancer mode 37 En Selecting the MULTI CH INPUT component 38 En Enjoying multi-channelsources in 2-channelstereo Enjoying pure hi-fistereo sound Enjoying unprocessed input sources 39 En USING VIDEO FEATURES Displaying the input source information 40 En Selecting the OSD mode Playing video sources in the background 41 En ENJOYING SURROUND SOUND Enjoying multi-channelsources in 6.1-channelsurround 42 En Enjoying 2-channelsources in surround 43 En Using Virtual CINEMA DSP 44 En RECORDING 45 En FM/AM TUNING Automatic tuning 46 En Manual tuning 47 En Automatic preset tuning 48 En ■Automatic preset tuning options Manual preset tuning 49 En Selecting preset stations 50 En Exchanging preset stations 51 En 52 En XM® SATELLITE RADIO TUNING ■Information from XM Satellite Radio Inc 53 En Connecting XM Passport System 54 En XM Satellite Radio controls and functions ■Front panel functions ■Remote control functions 55 En Activating XM Satellite Radio 56 En Basic XM Satellite Radio 57 En Selecting the XM Satellite Radio search mode ■All Channel Search mode 58 En ■Category Search mode 59 En ■Preset Search mode 60 En ■Direct Number Access mode 61 En Setting the XM Satellite Radio preset channels 62 En Displaying the XM Satellite Radio information ■Displaying the XM Satellite Radio information in the front panel display 63 En ■Displaying the XM Satellite Radio information in the OSD 64 En SOUND FIELD PROGRAMS ■Elements of a sound field Selecting sound field programs ■Front panel operations ■Remote control operations Sound field program descriptions ■For movie/video sources 66 En ■For music sources 67 En Changing sound field parameter settings 68 En ■Sound field parameter descriptions 69 En 70 En 71 En 72 En 73 En SET MENU ■Basic setup BASIC SETUP ■Manual setup MANUAL SETUP 74 En ■Signal information SIGNAL INFO 75 En Using SET MENU 76 En 1 SOUND MENU ■Speaker settings A)SPEAKER SET 77 En 78 En Speaker level 79 En ■Speaker distance C)SP DISTANCE ■Center graphic equalizer D)CENTER GEQ ■Low-frequencyeffect level E)LFE LEVEL 80 En Dynamic range ■Audio settings G)AUDIO SET 81 En 2 INPUT MENU ■Input/output assignment 82 En Input mode Input rename 83 En Volume trim 3 NET/USB MENU ■Network settings A)NETWORK 84 En ■Playback styles B)PLAY STYLE 85 En ■Network information C)INFORMATION 4 OPTION MENU ■Display settings A)DISPLAY SET 86 En Memory guard 87 En ■Parameter initialization C)PARAM. INI Zone set 88 En ■XM Radio setting E)XM RADIO SET (U.S.A. and Canada models only) 89 En ADVANCED SETUP 90 En ■Speaker impedance SP IMP ■Factory presets PRESET ■Network reset N-RESET 91 En ■Remote control TUNER ID REMOTE TUN ■Remote control XM ID REMOTE XM ■Tuner frequency step TU 92 En REMOTE CONTROL FEATURES Controlling this unit, a TV, or other components ■Controlling a TV 93 En ■Controlling other components 94 En 95 En Setting library codes ■Setting remote control AMP ID library codes ■Setting remote control TUNER ID library 96 En Resetting all remote control codes 97 En USING MULTI-ZONECONFIGURATION Connecting Zone ■Multi-zoneconfiguration and Zone 2 connections 98 En Controlling Zone ■Controlling Zone 2 with the front panel 99 En ■Setting the remote control to the Zone 2 mode ■Controlling Zone 2 with the remote control 100 En USING iPod® Controlling iPod ■Controlling iPod in the simple remote mode ■Controlling iPod in the menu browse 102 En USING NETWORK/USB FEATURES Navigating the network and USB menus 103 En 104 En Using a PC server or YAMAHA MCX-2000 ■Installing Windows Media Connect on your PC 105 En ■Registering this unit on the YAMAHA Using the Internet radio ■Storing your favorite Internet radio stations with bookmarks 106 En Using a USB memory device or a USB portable audio player 107 En RESETTING THE SYSTEM 108 En TROUBLESHOOTING ■General 109 En 110 En 111 En ■Tuner ■XM Satellite Radio (U.S.A. and Canada models only) 112 En ■Remote control ■iPod 113 En ■ Network and USB 114 En 115 En GLOSSARY Audio information ■Dolby Digital ■Dolby Digital EX ■Dolby Pro Logic 117 En Video information ■Component video signal ■Composite video signal ■S-videosignal Sound field program information SPECIFICATIONS We Want You Listening For A Lifetime GPL/LGPL 119 En APPENDIX-i APPENDIX-ii APPENDIX-iii APPENDIX-iv LIST OF REMOTE CONTROL CODES APPENDIX-v APPENDIX-vi APPENDIX-vii APPENDIX-viii TAPE DECK TUNER OTHER AUDIO