■Speaker impedance SP IMP.
Use this feature to set the speaker impedance of this unit so that it matches that of your speakers.
Choices: 8ΩMIN, 6ΩMIN
•Select “8ΩMIN” to set the speaker impedance to 8 Ω .
•Select “6ΩMIN” to set the speaker impedance to 6 Ω .
SP IMP. | Speaker | Impedance level |
|
|
|
|
| If you use one set (A or B), |
|
| the impedance of each |
|
| speaker must be 8 Ω or |
|
| higher. |
| Front |
|
| If you use two sets (A and | |
|
| |
|
| B), the impedance of each |
8ΩMIN |
| speaker must be 16 Ω or |
|
| higher.* |
|
|
|
| Center |
|
|
| The impedance of each |
|
| |
| Surround | speaker must be 8 Ω or |
|
| higher. |
| Surround back | |
|
| |
|
|
|
|
| If you use one set (A or B), |
|
| the impedance of each |
|
| speaker must be 4 Ω or |
|
| higher. |
| Front |
|
| If you use two sets (A and | |
|
| |
|
| B), the impedance of each |
Ω |
| speaker must be 8 Ω or |
6 MIN |
| higher. |
|
| |
|
|
|
| Center |
|
|
| The impedance of each |
|
| |
| Surround | speaker must be 6 Ω or |
|
| higher. |
| Surround back | |
|
| |
|
|
|
*The Canada model cannot use two separate speaker systems (A and B) simultaneously when “SP IMP.” is set to “8ΩMIN”.
ADVANCED SETUP
■Factory presets PRESET
Use this feature to reset all the parameters of this unit to the initial factory settings (see page 108).
Choices: CANCEL, RESET
•Select “CANCEL” not to reset any parameters of this unit.
•Select “RESET” to reset the parameters of this unit.
Notes
•This setting completely resets all the parameters of this unit including the “SET MENU” parameters. However, the advanced setup menu parameters will not be initialized.
•The initial factory settings are activated next time you turn on this unit.
■Network reset N-RESET
Use this feature to reset the network settings of this unit (see page 84) to the initial factory settings.
Choices: CANCEL, RESET
•Select “CANCEL” not to reset any network settings of this unit.
•Select “RESET” to reset the network settings of this unit.
Notes
•The initial factory settings are activated next time you turn on this unit.
•When the network settings are reset, “DHCP” in “NET/USB MENU” is automatically set to “ON” (see page 84) and the registered client ID of this unit on your YAMAHA
■Remote control AMP ID REMOTE AMP
Use this feature to set the AMP ID of this unit for remote control recognition (see page 96).
Choices: ID1, ID2
• Select “ID1” when the remote control AMP ID library code is set to “00001”.
• Select “ID2” when the remote control AMP ID library code is set to “00002”.
Note
You need to set the corresponding remote control AMP library code for the remote control (see page 96).
OPERATION | ADVANCED |
|
|