S400 & S600 User’s Guide | 9 |
|
|
Refer to Figure 9 and follow the procedure below.
1.Slide the media supply guide (a), media guide (b), and the outer edge guides on both the platen guide rod (c) and the lower guide rod (d) as far out from the printer frame as possible.
2.Open the head open lever (e) to raise the printhead (f).
3.Remove the hold down hook (g).
4.Thread the media through the printhead as shown in Figure 9.
5.From the front of the printer, pull the media through the printhead until approximately 24" of media extends out from the printer. Remove the labels from the backing of the 24" of media that extends from the front of the printer.
6.Align the inside edge of the media with the edge guide mark (h) near the left side of the
7.Thread the label backing behind the lower label available sensor (i), through the slot under the rewind power roller (j), and below the lower guide rod (k) to the backing rewind spindle (l). Then, wind the backing material around the backing rewind spindle three or four times in a counterclockwise direction. To insure proper winding, press the edge of the backing material against the round plate at the far end of the spindle.
| h |
f | i |
| |
| e |
| j |
| a |
| g |
| c |
| b |
| l |
| d |
| k |
Figure 9