S400 & S600 User’s Guide

33

 

 

Media Rest Position Adjustment

This procedure sets the end-of-label position relative to the Tear-Off plate or cutter. Adjust this if your label is not being torn or cut at the correct point.

1.Briefly press the MODE button twice. The PAUSE and POSITION LEDs turn on.

2.Press UP (FEED) or DOWN (CANCEL) to adjust the current setting.

3.Briefly press the MODE button twice. The MODE LEDs will flash on and off to indicate that the settings have been saved in memory.

4.Press PAUSE to exit the pause mode. The PAUSE LED turns off.

Top of the Label Position Adjustment

This procedure positions the printing on the label relative to the top edge of the label. Adjust this if your printing is too close or too far away from the top or bottom edge of the label.

1.Briefly press the MODE button twice, then press and hold it for about five seconds until the lights change. The PAUSE, DARKEN, and CALIBRATE LEDs turn on.

2.Press UP (FEED) or DOWN (CANCEL) to adjust the current setting.

3.Briefly press the MODE button twice. The MODE LEDs will flash on and off to indicate that the settings have been saved in memory.

4.Press PAUSE to exit the pause mode. The PAUSE LED turns off.

Media Sensor Position Adjustment

This procedure is covered in Getting Ready to Print.

Ribbon Supply Spindle Adjustment

This procedure is covered in Getting Ready to Print.