10S400 & S600 User’s Guide
8.To hold the media against the spindle, place the hold down hook over the backing and insert both ends into the small slots in the round plate at the far end of the spindle. Again, rotate the backing rewind spindle counterclockwise to remove any slack in the backing material.
9.Adjust all of the guides:
nPush the media supply guide inward until it is just touching the outer side of the media supply roll, then lock the guide in place with its locking screw. The guide must not cause pressure or excessive drag on the media supply roll.
nAdjust the outer edge guides on both the lower guide rod and the platen guide rod until they just touch the outer edge of the media and backing without causing the material to buckle.
nAdjust the media guide until it just touches the outer edge of the media without causing the material to buckle.
10.See “Adjusting the Media Sensor” later in this chapter to adjust the me- dia sensor.
NOTE: In the
Removing the Label Backing Material
quired)
When the amount of backing wound on the backing rewind spindle reaches full capacity, the backing rewind spindle full sensor activates, the paper/ribbon light flashes, and printing pauses.
To remove the backing material, follow these steps (you don’t need to power off the printer for this procedure):
1.Unwind about 24" of backing from the backing rewind spindle and cut it off at the spindle.
2.Pull out the hold down hook and slide the backing material off of the spindle and discard.
3.Feed the new starting edge of the backing through the mechanism and attach it to the backing rewind spindle as described in the loading proce- dure.
NOTE: While holding the media in position against the