Manuals / Zebra Technologies / Computer Equipment / Printer

Zebra Technologies H 2824-Z user manual Operator Controls, Power Switch, Feed Button, Status Light

Models: H 2824-Z

1 63

Download 63 pages 23.86 Kb

Page 23

Getting Started

Operator Controls

Operator Controls

Power Switch

Press backward to turn ON or forward to OFF the printer.

Caution • The power should be turned off before connecting or disconnecting the communications and power cables.

Feed Button

•Tapping the Feed button forces the printer to feed one blank label.

•Holding the Feed button forces the printer to feed continuously.

•Pressing the Feed button takes the printer out of a “pause” condition. The printer is put into “pause” by either a programming command or an error condition. See “What the Status Light is Telling You” in the Troubleshooting chapter.

•Use the Feed button for printer setup and status (see “Feed Button Modes” in the Troubleshooting chapter).

Status Light

Functions as a printer operational indicator (see “What the Status Light is Telling You” in the Troubleshooting chapter).

Feed Status

Button Light

Power

Switch

22

LP 2824-Z User Guide

980531-001 A

Image 23

Zebra Technologies H 2824-Z user manual Operator Controls, Power Switch, Feed Button, Status Light

Contents

2824-Z User Guide Customer Order # 980531-001 a FCC Compliance Statement Proprietary StatementProduct Improvements Limitation of Liability Canadian DOC Compliance StatementLiability Disclaimer Contacts Preface Support Environmental ManagementDocument Conventions Related Documents Preface Contents Operations & Options Hello Introduction What’s in the Box? Opening the printer Inspecting the Printer After opening the printer, check the media compartment Reporting Damage Closing the printer Introduction Modes of Printing Getting Started Attaching Power Supply Loading Roll Media Adjusting the Roll Holders Placing the Roll in the Media Compartment Adjusting the Guides Status Light Power SwitchOperator Controls Feed Button Printing a Test Label Interface Cable Requirements Hooking Up the Printer and Computer Ethernet Interface Requirements Communicating with the Printer Adjusting the Print Quality Adjusting the Print Width Operations & Options Thermal Printing Replacing Supplies XA MMP XZ XA JUS XZ Printing in Peel-Mode Operations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Cleaning Maintenance Print Head Considerations Media Path Considerations Sensors Platen Considerations Lubrication Removal Replacing the Platen Replacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Printer is on and in an idle state TroubleshootingResolutions Printer is not receiving power Either the media or ribbon is out Printer has failed its power on self test PostThere is a shortage of memory Printer is receiving data Flash memory is not programmed Print head is under temperaturePrint head is over temperature Printed image does not look right Print Quality ProblemsRibbon sensor settings did not print No print on the label Label format was sent to, but not recognized by, the printer Manual Calibration Recalibration Troubleshooting TestsPrinting a Configuration Label Communications Diagnostics Resetting the Factory Default Values Feed Button Modes Power Off Mode Communications Diagnostics Mode Battery Interfaces Universal Serial Bus USB Connector 33-34 Parallel Interface Rx+ ZebraNet PrintServer II for Ethernet Networks Serial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp