Battery | Zebra Technologies H 2824-Z manual

Troubleshooting

Battery

Battery

The optional Real Time Clock requires a three-volt lithium battery on the main printed circuit board. You can discern a low or flat battery if the printer provides a consistently delayed date stamp. Only a qualified technician observing precautions against both static discharge and electric shock can replace the battery.

Caution • Risk of explosion if battery is replaced with an incorrect type.

Important • Recycle batteries according to local your guidelines and regulations.

54

LP 2824-Z User Guide

980531-001 A

Image 55

Zebra Technologies H 2824-Z user manual Battery

Contents

2824-Z User Guide Customer Order # 980531-001 a Product Improvements Proprietary StatementFCC Compliance Statement Liability Disclaimer Canadian DOC Compliance StatementLimitation of Liability Contacts Preface Document Conventions Environmental ManagementSupport Related Documents Preface Contents Operations & Options Hello Introduction What’s in the Box? Opening the printer Inspecting the Printer After opening the printer, check the media compartment Reporting Damage Closing the printer Introduction Modes of Printing Getting Started Attaching Power Supply Loading Roll Media Adjusting the Roll Holders Placing the Roll in the Media Compartment Adjusting the Guides Status Light Power SwitchOperator Controls Feed Button Printing a Test Label Interface Cable Requirements Hooking Up the Printer and Computer Ethernet Interface Requirements Communicating with the Printer Adjusting the Print Quality Adjusting the Print Width Operations & Options Thermal Printing Replacing Supplies XA MMP XZ XA JUS XZ Printing in Peel-Mode Operations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Cleaning Maintenance Print Head Considerations Media Path Considerations Sensors Platen Considerations Lubrication Removal Replacing the Platen Replacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Printer is on and in an idle state TroubleshootingResolutions Printer is not receiving power Either the media or ribbon is out Printer has failed its power on self test PostThere is a shortage of memory Printer is receiving data Print head is over temperature Print head is under temperatureFlash memory is not programmed Printed image does not look right Print Quality ProblemsRibbon sensor settings did not print No print on the label Label format was sent to, but not recognized by, the printer Manual Calibration Printing a Configuration Label Troubleshooting TestsRecalibration Communications Diagnostics Resetting the Factory Default Values Feed Button Modes Power Off Mode Communications Diagnostics Mode Battery Interfaces Universal Serial Bus USB Connector 33-34 Parallel Interface Rx+ ZebraNet PrintServer II for Ethernet Networks Serial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp