Leaving the Setup Mode
You can leave the program mode at any time by pressing the SETUP/EXIT key. The “SAVE CHANGES” display will appear. There are five choices, described below. Pressing the INCREMENT (+) or DECREMENT (-) key displays other choices and pressing the SELECT key selects the displayed choice.
PERMANENT -- Permanently saves the changes. Values are stored in the printer even when power is turned off.
TEMPORARY -- Saves the changes until changed again or until power is turned off.
CANCEL -- Cancels all changes since pressing the SETUP/EXIT key except the darkness and tear-off settings (if they were changed).
LOAD DEFAULTS -- Loads factory defaults.
LOAD LAST SAVE -- Loads values from the last permanent save.
Zebra Z4M Printer User’s Guide | 39 |