Zebra Technologies Z4M manual Initialize Memory Card, Initialize Card, Initialize Flash Memory

Display Shows Action/Explanation

Initialize Memory Card

CAUTION: Perform this operation only when it is necessary to erase all previously stored information from the optional memory card. Press the SETUP/EXIT key to bypass this function.

	1.	Press the INCREMENT (+) key to select “YES.”
			If your printer is set to require a password, you will now be
			prompted to enter the password. Enter the password and then
			press the SELECT key.
	2.	The display will ask “INITIALIZE CARD?”. Press the INCREMENT (+)
		key “YES.”
INITIALIZE CARD	3.	The front panel LCD will ask “ARE YOU SURE?”.
	4.	Press the INCREMENT (+) key “YES” to begin initialization.
			or
		Press the DECREMENT (-) key “NO” to cancel the request and return to
		the “INITIALIZE CARD” prompt.
	5.	Press the SETUP/EXIT key followed by the SELECT key. If initialization
		is still in process, the front panel display will flash back and forth between
		the two phrases “CHECKING B: MEMORY” and “PRINTER IDLE.”
		When initialization is complete, the printer will automatically exit the
		configuration mode and the front panel will display “PRINTER READY.”
	NOTE:		Depending on the amount of memory in the memory card,
			initialization may take up to five minutes to complete.
	Initialize Flash Memory
	CAUTION: Perform this operation only when it is necessary to erase all
	previously stored information from the FLASH memory. Press the
	SETUP/EXIT key to bypass this function.
	1.	Press the INCREMENT (+) key to select “YES.”
			If your printer is set to require a password, you will now be prompted
			to enter the password. Enter the password and then press the
			SELECT key.
	2.	The display will ask “INITIALIZE FLASH?”. Press the INCREMENT (+)
		key “YES.”
INIT FLASH MEM	3.	The front panel LCD will ask “ARE YOU SURE?”.
	4.	Press the INCREMENT (+) key “YES” to begin initialization.
			or
		Press the DECREMENT (-) key “NO” to cancel the request and return to
		the “INITIALIZE FLASH” prompt.
	5.	Press the SETUP/EXIT key followed by the SELECT key. If initialization
		is still in process, the front panel display will flash back and forth between
		the two phrases “CHECKING E: MEMORY” and “PRINTER IDLE.”
		When initialization is complete, the printer will automatically exit the
		configuration mode and the front panel will display “PRINTER READY.”
	NOTE:		Depending on the amount of free FLASH memory, initialization may
			take up to one minute to complete.

44 Zebra Z4M Printer User’s Guide