![](/images/new-backgrounds/1264812/26481295x1.webp)
Configuration and Calibration Sequence
| Display Shows | Action/Explanation |
|
| PRINTER READY | Normal printer operation. |
|
|
|
|
|
Setting Print Parameters
| Adjusting Print Darkness Press the INCREMENT (+) key to increase darkness. |
| Press the DECREMENT |
| Default: +10 |
| Range: 0 to +30 |
| Darkness settings are dependent upon a variety of factors, including ribbon |
| type, media, and the condition of the printhead. You may adjust the darkness |
| for consistent |
| If printing is too light, or if there are voids in printed areas, you should increase |
DARKNESS | the darkness. If printing is too dark, or if there is spreading or bleeding of |
| printed areas, you should decrease the darkness. |
| The FEED key self test on page 76 can also be used to determine the best |
| darkness setting. Since the darkness setting takes effect immediately, you can |
| see the results on labels that are currently printing. |
| CAUTION: Set the darkness to the lowest setting that provides good print |
| quality. Darkness set too high may cause ink smearing and/or it |
| may burn through the ribbon. |
| Darkness settings also may be changed by the driver or software settings. |
|
|
| Adjusting the |
| value, press the DECREMENT |
| key adjusts the |
TEAR OFF | Default: +0 |
| Range: |
| This parameter establishes the position of the media over the |
| bar after printing. The label and backing can be torn off or cut between labels. |
|
|
40 | Zebra Z4M Printer User’s Guide |