90Configuration

Standard Control Panel Parameters

Table 11 • Printer Parameters (Page 18 of 25)

 

Language/Parameter

Action/Explanation

 

 

 

ZPL only

Set Control Prefix Character

 

 

The printer looks for this two-digit hex character to indicate the start of a

 

 

 

 

ZPL/ZPL II control instruction.

 

 

Note • Do not use the same hex value for the control, format, and

 

 

delimiter character. The printer must see different characters to

 

 

work properly.

 

 

Default Value: 7E ~

 

 

 

 

Range: 00 to FF

 

 

To change the value shown:

 

 

1. Press SELECT to select the parameter.

 

 

2. Press MINUS (-)to move to the next digit position.

 

 

3. Press PLUS (+) to increase the value of the digit.

 

 

4. Press SELECT to accept any changes and deselect the parameter.

 

 

 

ZPL only

Set Format Prefix Character

 

 

The format prefix is a two-digit hex value used as a parameter place marker

 

 

 

 

in ZPL/ZPL II format instructions. The printer looks for this hex character

 

 

to indicate the start of a ZPL/ZPL II format instruction. See the

 

 

Programming Guide for ZPL, ZBI, Set-Get-Do, Mirror, and WML for more

 

 

information.

 

 

Note • Do not use the same hex value for the control, format, and

 

 

delimiter character. The printer must see different characters to

 

 

work properly.

 

 

Default Value: 5E ^

 

 

Range: 00 to FF

To change the value shown:

1.Press SELECT to select the parameter.

2.Press MINUS (-)to move to the next digit position.

3.Press PLUS (+) to increase the value of the digit.

4.Press SELECT to accept any changes and deselect the parameter.

 

 

 

79695L-003

Z Series®/RZ™ Series User Guide

1/11/11