| English |
| 中 文 |
|
| 7. Operation | 7. 操作 | ||
|
|
|
|
|
OP1
OP2
OP3
OP4 | (1) |
OP5 |
|
■STARTING ENGINE
WARNING
The cutting head will start rotating upon the engine starts.
1.Feed fuel and chain oil into their respective tanks and tighten the caps securely. (OP1)
(1)Fuel
(2)Chain oil
2.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects as it will start rotating upon starting of the engine.
3.Push the pump several times until overflown fuel flows out in the clear tube. (OP2)
4.Move the choke lever to the closed position. (OP3)
(1)Choke lever
(2)Close
(3)Open
5.Set the stop switch to the "RUN" position.
Place the unit on a flat place. Keep the cutting head clear of everything around it. (OP4)
(1) Stop switch
6.While holding the unit firmly, pull out the starter rope quickly until engine fires. (OP5)
IMPORTANT
•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.
7.Move the choke lever downward to open the choke. And restart the engine. (OP3)
8.Allow the engine to warm up for a several minutes before starting operation.
■启动引擎
警 告
引擎启动时切割头将开始旋转。
1.将燃料和链条油分别加入各自的油箱 中，然后牢牢地拧紧油箱盖子。
（OP1）
（1）燃料 （2）链条油
2.将机器放置在平坦、坚固的地方。 由于引擎启动时切割头将开始旋转。 因此请使其指向地面并保持周围没有 异物。
3.推泵数次，直至清洁的管子中溢出 燃料。（OP2）
4.将进气杆移至关闭位置。（OP3）
（1）进气杆 （2）关闭 （3）开通
5.将止动开关设至“RUN（运行）” 位置。
将机器放置在平坦、坚固的地方。 保持切割头周围没有任何异物。 （OP4）
（1）止动开关
6.紧握住机器，快速抽拉起动器的拉 绳直至引擎着火。（OP5）
重 要
・避免将拉绳拉到底或通过松开旋钮使
其返回。否则会导致起动器失败。
7.向下操作进气杆以开通进气门。然 后重新启动引擎。（OP3）
8.在开始操作之前请先让引擎预热几 分钟。
17
