60 ZOOM B9.1ut
Other Functions
B9.1ut
Bass amplifier
Mixer
Bass guitar
BALANCED OUT
connector
OUTPUT jack
If you use the BALANCED OUT R connector,
The [PRE/POST] switch lets you control the
type of signal supplied as direct output. To use
the signal after effect processing, select the
"POST" position (switch engaged). To use the
signal before effect processing, select the "PRE"
position (switch disengaged). The Accelerator is
active also if the "PRE" setting is selected.
When the BALANCED OUT connectors are
used to connect the B9.1ut to a PA mixer or
similar, ground loops (electrical signal loop
that can occur when multiple components in a
system are grounded separately) may lead to
hum noise. In such a case, set the GROUND
switch to the "LIFT" position (switch engaged).
Often this will eliminate or reduce the hu m.

Checking the B9.1ut

version

To check the system version of your B9.1ut,
proceed as follows.

In manual mode or play mode,

1.

press the [SYSTEM] key.

The SYSTEM menu for parameters that apply to
all patches appears.
70*2<7:LS
(*;0=,

Turn the [TYPE] knob to bri ng up

2.

the "System Version" indi cation.

The current system version is shown on the
second line of the display.
:`Z[LT=LYZPVU
[TYPE] knob Current version

HINT

The system version is also brie y shown during
power-up of the B9.1ut.

After checking the sys tem version,

3.

press the [EXIT] key.

The unit returns to the previous mode.

Editor/librarian software

for the B9.1ut

ZOOM CORPORATION makes an editor/
librarian software application for the B9.1ut
available for download on its web site.
To use the software, the computer must have
a MIDI interface, and a connection must be
established between the MIDI IN/MIDI OUT
connectors of the computer and the MIDI OUT/
MIDI IN connectors of the B9.1ut. The software
then makes it possible to store patch data of the
B9.1ut on the computer, edit the data, and copy
edited patch data back to the B9.1ut.
Web site of ZOOM CORPORATION
http://www.zoom.co.jp